品牌:F10
起订:10千克
供应:1000千克
产品品牌:F10
产品型号:大理石结晶粉
产地:美国 | 规格:样品 |
适用范围:大理石 | 防护用途:表面石材 |
作用机理:成膜型 | 防护效果:综合型 |
界面作用力:憎水型 |
F10 MarbleCrystallizingPower
This product can be used for crystallizing processing and regular maintenance of various marble. It can make the marble surface bright and shining and can enable the marble surface harder and more wearable. There will be no damage to the stone after long use. It will not influence the air conductivity of the stone and will not change the natural color and luster of the stone.
Directions for use:
1.Surface must be clean and dry. Make sure all waxes ,floor finish or other coating are removed.
2.Mix the crystallizing power with the clear water. In the proportion of 1to 2 to a viscous mixture before applying it to the stone surface.
3.Put a white or red polishing pad under the crystallizing machine.
4.Move the crystallizing machine onto the surface, first move left and right then move up and down. Polish until the floor becomes glossy and lustrous. Each operation covers about 3~5 square meters.
5.After a bright crystallizing surface is seen on the stone surface, scrape the pastry substance to the next operating area with a wipe. Continue to polish by adding only a bit of new crystallizing power. Repeat such polishing till a lot of bubbles are seen on the floor and absorb them with a water sampling machine. Then, add new crystallizing power again and operate by using the foregoing method.
6.Repeat the above method to achieve a more crystalline and shiny effect.
7.Clean the floor with clear water and dry the floor when the entire crystallizing operation is completed.
Warning:
This product is to be used only for floor crystallization.
Have no injure with surroundings environment all to person.
Prohibition againstedibility.
Keep it away from children s reach.
F10大理石结晶粉
本产品适用于各种大理石的结晶处理及日常养护,可以是石材表面光亮、坚硬且有较好的重涂性。长时间使用,保护石材不受损坏,不影响石材的透气性,不改变石材的天然色泽。
使用说明:
1、确保石材表面的洁净、干爽。清除地表原有的蜡及污物。
2、使用前将结晶粉与清水以1:2的比例调和。
3、将结晶机安装上白洁垫。
4、在地表上以先左右后上下的顺序移动晶面机,研磨直到地表光亮,每次操作区域3~5平米。
5、石材表面出现结晶,用干净的布将剩余的物体移至下一个需要工作的区域并加入新的结晶粉,继续研磨,重复此操作至地面出现大量的泡沫然后用吸水机吸尽。然后加入新的结晶粉重复以上操作。
6、重复以上操作得到更加完美的效果。
7、当整个结晶操作完成之后,用清水冲洗并吸干。
警告:
此产品只用作地表结晶。
对人体及环境没有危害。
禁止服用
放于儿童接触不到的地方。